Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
builds:etching:ibanez_mostortion [2020/02/09 13:54]
jeremy
builds:etching:ibanez_mostortion [2020/02/09 18:57] (current)
jeremy
Line 8: Line 8:
 |  Monastortion populated PCB  | |  Monastortion populated PCB  |
  
-Building this thing didn't go that flawlessly though. I drilled one hole too much next to the 220nF and put pot covers on the tone pots before checking if they would fit that way. Which they didn't of course so I had to pull of the covers again. This cost me one pot which I managed to pull apart completely. I also had two swap the 47µF SMD cap that I used in the first place for a regular through-hole cap because with the SMD cap pin 3 of the bass pot got blocked by the cap. +Building this thing didn't go that flawlessly though. I drilled one hole too much next to the 220nF and put pot covers on the tone pots before checking if they would fit that way. Which they didn't of course so I had to pull of the covers again. This cost me one pot which I managed to pull apart completely. I also had to swap the 47µF SMD cap that I used in the first place for a regular through-hole cap because with the SMD cap pin 3 of the bass pot got blocked by the cap.